Plastic Adhesive Ligth

To ensure a safe application with maximum performance, follow the instructions below:

Application:
• Sand and degrease the surface to be prepared, removing all oil, dust, corrosion and water;
• Remove the desired amount and add the catalyst at a rate of 20 drops per 100 grams;
• Mix until a homogeneous mass is obtained;
• Apply the Ligth Polibra Plastic Adhesive until the place to be corrected is a little higher than the surrounding surface;
• After 1 hour of application, level the surface with dry sandpaper (sandpaper 80 - 150 and end with sandpaper 220 - 320); • Drying time for sanding: 25 ° C = 1 HOUR.

 Tips:
• The product should be applied directly over a bare sheet
• In the adhesive (catalysis) preparation, use the correct quantity of catalyst, thus avoiding blistering problems.
• Do not replace the mixture already prepared into the can.
• Wait for the recommended drying time, in order to prevent lapping.
• Avoid forced drying at high temperatures, because it may cause cracking, blistering and loss of adhesion.
• Wet sanding of the adhesive is not recommended, because the humidity retained in the adhesiveduring the sanding with water may cause problems on the surface and finishing.
• Isolate the repair location with Maxi Rubber Primer PU before applying the finishing.

Indicated for correcting imperfections in vehicles body work, metallic surfaces, galvanized parts, machines and equipment. It is also recommended for gluing or correcting imperfections on marble, granite and in the gluing of vat tanks.